Biofa BIOFA 2059 Special Professional Oil for Parquet and Furniture Solvent Free, Colourless, 2.5 litres

BIOFA 2059 natural oil for parquet and furniture without solvents, colourless, impregnates and protects the wood inside. Transparent finish, high resistance, creates a surface resistant to moisture, dirt and wear and tear. According to DIN EN14342 (standard for parquet), for indoor surfaces, or with good absorption such as furniture and wooden floors, made from high-quality natural raw materials, natural wood oil suitable for impregnation. This and impress and impress and impress And, almost no yellowing ;Max. 1.1 g/l VOC Slightly revives treated woods can be painted in various custom colours BIOFA oil chart, Biofa wood chart, RAL and NCS colours. Very high yield: 50 – 70 m² /lt. Treatment. The bottom must be dried; airless: nozzle: 0, 23-0, 28 mm, spray pressure 4 bar, material pressure 80 bar; for spraying with cup gun with air pressure: nozzle: 1.5-1, 8 mm, spray pressure: 2, 5-3, 5 bar; airless: nozzle: 0, 23-0, 1.10. 2 in 2 in 24 bar, material pressure 80 bar; on request also can be integrated in RAL and NCS colours yield: on the first coat 25-35 ml/M2 respectively 28-40 m2/lt. On the second coat 10-15 ml/M2 respectively 66-100 m²/lt. All over with two coats 35-50 ml/M2. Consumption depends on the absorption and composition of the base. Cleaning tools: immediately after use with Napona 2090 or thinner 0500. Dried or damp surfaces can be cleaned with Nacasa Universal Cleaner 4059. For care we recommend Naplana 4061. Look on old floors before oiling, all joints must have been closed. Generally it should be noted that no oil gets into the joints, especially with floating parquet, if this is not guaranteed, oil can escape or there may be noise when walking on it. Treatment: The base must be dried (wood moisture mas. 14%), absorbent, no leaks, no dirt and grease. Remove old paint well. Sand well furniture surfaces with 180-240 grit and minimum ladder flooring fine/grain 120, surface temperature must be at least 16 °C. Processing on parquet: roll well with a fine layer of cold parquet oil. After 30 minutes and do not first treat only the absorbent parts if necessary with little oil. Then massage the complete surface with a green pad. Absolutely no oil remains on the surface. After drying, the surface must be filled and not shiny. Repeat the cycle with much less oil and polish at the end with a white pad. Furniture processing: Spread the parquet oil well with a brush, roller, sponge or spray. After approx. 20-30 min. Polish the surface with a red/green cloth, cloth or pad until dry. Finally polish again with a white pad. No oil remains on the surface. After drying, the surface must be filled and not shiny Repeat the process with little product if necessary. Parquet oil dries after approximately 12-13 hours (air humidity 23° with 50-55%). Air well. Total drying after 7-10 days. Work material soaked in the product such as rags, sponges, clothes etc. Store tightly in metal containers or water and allow to dry on a non-combustible surface (danger of self-combustion). We recommend that you always do a test of prior application. Further information on the product label and for use refer to the technical and safety data sheet available online. Declared components and available raw materials brochure. Safety Warning May cause an allergic reaction. Contains sensitising substance. May cause an allergic reaction. Always read the label and product information before use (English language not guaranteed). Repeated exposure may cause skin dryness or cracking.