BOSS Audio Systems BASS10K Amplified Car Subwoofer - Low Profile, 10 Inch, 8 Gauge Amplifier Wiring Kit, Remote Subwoofer Control, for Vehicles Needing Bass with Limited Space

KIT – 20’/8G Red Power Cable, Competition Fuse Holder, 3’/8G Ground Cable, 16’/18G Blue Turn-On Wire, 30’/16G Speaker Wire, 20’ RCA Interconnect, 6’ Split Loom Tubing, 4" Wire Ties, 3 Rubber Grommets, 5/16”-1/4" Ring Terminals, 4 Speaker Terminals

Space Saver - If you are tight on space, this is a great solution for you. The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options

Pulse Width Modulated - PWM simplifies power supplies. It controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. Efficiency. Increased reliability

Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)

High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BASS10K to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs

Low Level Inputs - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BASS10K with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers

Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it

Specs - Dimensions: 14” x 12.3” x 3.3”, Weight: 11.35 lbs. Phase control. LED status indicator. Thermal, Short and Overload Protection Circuits. High Performance Voice Coil. Rubber Surround. Aluminum Cone