DJI Power Station, 1024 Wh LiFePO4 Battery, 2200 W Solar Generator, Emergency Power for Home, 4-in-1 Quick Charge, Ultra Quiet, Camping & Motorhomes, Off-Grid

Notes: * The appearance of the product sold in different countries and regions may vary. Please pay attention to the actual item. 1. At a room temperature of 25°C, Power 1000 can deliver a continuous peak power of 2200W until the battery runs out. The data was measured in a DJI laboratory. 2. Measured at a battery temperature of approx. 25 °C and a battery level of approx. 50% Duration may vary due to differences in battery temperature and battery level. Please refer to the actual use. It is recommended to use the maximum power if the battery has a moderate temperature and a relatively high battery level. The data was measured in a DJI laboratory. 3. Requires certain accessories that must be purchased separately. 4. Supports DJI Mavic 3 Pro, Mavic 3 Classic, Mavic 3 and Mavic 3 Enterprise series. 5. Measured charging times from 10% to 95% battery for the DJI Mavic 3 Series Intelligent Flight Batteries using DJI Power 1000 (with the corresponding fast charging cable) compared to other charging stations (with a 65W charger). 6. Each USB-C port supports a maximum output power of 140W. The device to be charged must support the PD 3.1 protocol and be charged with a USB cable that meets EPR specifications. 7. Measured at 100 cm away from the DJI Power 1000 while charging in standard charging mode. For reference purposes only. 8. Measured under laboratory conditions at 25°C, charged in standard charging mode at 600W and at an output power of 1000W. 9. When used correctly, the DJI Power 1000 has an approximate life of 10 years, calculated based on a full charge/discharge cycle per day. This data is for reference only. Actual user experience may vary. 10. Measured under 25°C laboratory conditions with special battery cells and is for reference only. 11. At an ambient temperature of 25°C under laboratory conditions, the waiting time for the DJI Power 1000 to start charging is shortened by up to 1 hour after full discharge at rated power compared to conventional power stations. This happens as the device reaches a sufficiently low temperature faster. 12. The data was measured in a DJI laboratory. 13. The test data was collected under laboratory conditions at 25°C and is for reference only. 14. Requires the DJI Power adapter module for solar panel (MPPT) and solar panels. The aforementioned accessories are sold separately. The minimum time to fully charge was measured under laboratory conditions at 25°C and is for reference only. Actual charging time depends on factors such as the angle of sunlight and light intensity. The actual user experience may vary. Solar panels from the DJI certified brand Zignes are recommended. To use solar panels that are not officially recommended by DJI the connection of the solar panel must be switched to an XT60 interface. To avoid damage to the MPPT module and the power station, ensure that the no-load voltage of each solar panel is less than 30V. The output power of each solar panel connected to a single XT60 interface should not exceed 200W, with the total output power of the solar panels connected to the entire MPPT module being limited to 400W. 15. Calculation based on more than 6 hours of sunlight per day. 16. At a room temperature of 25 °C: when charging two smartphones with a battery capacity of approx. 17 Wh, the minimum charging time from 0% to 50% is 15 minutes with the PD fast charging protocol and a charging power of approx. 34W. When charging an Osmo Pocket 3, the minimum charging time from 0% to 80% is 16 minutes with the 65W charger. When charging selected laptops that support the PD protocol, the minimum charge time from 0% to 50% is 30 minutes when using the 140W USB-C power supply. Charging times may vary due to temperature, device model, battery capacity and device compatibility. Please refer to the actual use. The data was measured in a laboratory. 17. The standard warranty period is three years. By scanning the QR code on the case and completing the registration, you also get a two-year warranty period. 18. If multiple electrical devices are connected at the same time and the total output power does not exceed 2200 W, Power 1000 can power the connected device (or multiple devices) within 0.02 seconds in the event of a sudden power failure. 19. The device power does not exceed 2200W. 20. Compared to the standard dual 100W USB-C output ports.