GKU Upgraded Dash Cam Hardwire Kit with 8pcs Fuse Tap Set, 3-Meter Type-C ACC Hard Wire Kit, 12V-24V to 5V/2.5A Wiring Kit with Low Voltage Protection, 24H Parking Surveillance for all GKU Dashcams

The GKU Dash Cam Type-C Hardwire Kit compatible with USB-C D600 Series Dash Cams. -Warm tips: 1. Please make sure the ACC and BAT is connected correctly. 2. Please feel free to reach us if any professional help in need. 3. Please use the dedicated hardwire kit for the GKU D600 dash cam, Because the other brands of hardwire kits are not available for GKU dash cams. 4. The length of this hardwire kit is 11.5ft, suitable for most trucks, SUVs and other vehicles. 5. Please note that installation steps may vary by vehicle model and specific conditions. It is strongly recommended to refer to the vehicle manual or seek professional help before installation. -Instructions for installation 1. Make sure everything is ready and safe before installation. 2. Locate the car's fuse box. It is usually located under the dashboard on the driver's side or in the engine compartment. 3. Identify the ACC (Accessory) fuse slot in the fuse box. This slot provides power when the ignition is on. Locate the constant power fuse slot in the fuse box. This slot provides power even when the ignition is off. 4. Connect the red wire from the hardwire kit to the ACC fuse slot. Connect the yellow wire from the hardwire kit to the constant power fuse slot. You can use a fuse tap or a fuse adapter to make the connection. 5. Find a suitable grounding point near the fuse box. It should be a metal surface that is securely connected to the vehicle's chassis. 6. Connect the black wire from the hardwire kit to the grounding point using a ring terminal or a suitable grounding connector. 7. Once all the connections are secure, tuck away any excess wires and ensure they are safely routed to avoid interference with the vehicle's controls. 8. Test the hardwire kit by turning on the ignition. The dash cam should receive power and start functioning.