Schneider Electric EVlink Pro AC 22 kw Attached Cable MID 3 PH EV Charger

The EVlink Pro AC is a wall - mounted charging station for all electrical vehicles compliant with IEC61851-1 standard. It can also be floor - standing, either fixed on a pedestal, or integrated in a kit enclosure. Pedestal or kit enclosure must be ordered separately. It can be installed indoors and outdoors. The IP degree of protection is IP55. The IK degree of protection is IK10. The operating temperature is between -30°C and 50°C. The storage temperature is between -40°C and 80°C. The output type is a T2 socket-outlet with shutter T2 S, fixed on the front face of the station. All the contacts of T2S socket-outlet are silver-plated avoiding overheating. The nominal output power is 7.4 kW. It is supplied in single-phase 1P + N. The rated charging current is 32A under 220V to 240 VAC with a 50 Hz to 60 Hz frequency. It can be used with a TT, TN - S, TN-C-S or IT earthing system. The charging station is easy to install and to commission. It is recommended for homes, fleets, destination or at workplaces. The dimensions are Width 317 mm x Height 529 mm x Depth 153 mm. Its product weight is 7.2 kg. Its colour is dark grey RAL 7016. It embeds a built-in protection against residual direct current, with a 6 mA residual direct current detection device RDC - DD, and a 30 mA A-Si type residual current device RCD. An MNx under voltage tripping auxiliary is also integrated in the charging station for safety. Moreover, it is necessary to meet EV Ready requirements. The charging station can be fed by cable coming from the rear, the top or the bottom of it. To load an electrical vehicle, the access control is done by a user authentication through RFID or NFC badge. But the charging station can also be used for free access. The load starting can be time delayed. During the load time, the power can be limited to ensure the continuity of service and optimize the charging time of all the charging station based on a same feeding. It has 2 Ethernet RJ45 ports for LAN connection. The parameters are set up through eSetup app via Bluetooth or EcoStruxure EV Charging Expert. The charging station can be managed in standalone or in clustered architecture. The OCCP 1.6 communication protocol is used to connect to the supervision device. The available services are the charge detail records, the diagnosis capabilities and the load management. The charging station has the CE and EV Ready certification.