9V 1A Pedal Power Supply Adapter, DC Jack Center Negative Sleeve Positive, Barrel 5.5mm x 2.1mm, One Spot Charging Adaptor Wall Charger with 5 Way Daisy Chain Cables for Guitar Effects Pedal Stompbox

Powerful Chip, Multiple Protection DesignWith Precise plug-in and chip component design and production, the power adapter fully meets the six-level energy efficiency standard, ETL FCC CE RoHS safety certificates approved, and excellent performance protection functions, including overcurrent protection, overvoltage protection, overload protection, overheat protection, and short circuit protection, etc.

Anti-interference and Noise ReductionThe magnet ring can reduce noise disturbance and high-quality copper core daisy chain cable with special anti-hum. The professional noise isolation performance ensures you a quiet pedal chain condition while you play.

SpecificationPolarity: TIP NEGATIVE SLEEVE POSITIVE; Barrel Size: 5.5*2.1mm; Cord Length: 10 ft/305 cm(including 5 daisy chain cords). The adapter converts AC wall power to 9-Volt DC for powering single effect unit and other 9-volt battery devices. Note: Please carefully check your device's required polarity and connector size before purchasing.

5 Way Daisy Chain CordsYou can run five pedals on your pedal board at the same time. It eliminates the need to use and constantly replacement of batteries. The output port adopts the tuning fork groove plug for better connection and stable power transmission.

Battery-Free PerformanceYou won’t need to worry about dead batteries in your pedalboard ruining your performance when using a DC 9-Volt Power Adaptor. You can ensure consistent, battery-free performance when you directly power it.

Wide Compatibility This pedal power adaptor works with guitar stompbox and 9V tip-negative keyboards, electronics with the exact voltage requirements. It is compatible with most effects pedal models from BOSS, Behringer, JOYO, TC Electronic, Donner, JHS, NUX, MXR, Caline, Rowin, Ibanez, etc. Note: It is NOT compatible with Casio CTK-5000.