DenTek Temparin Max, Home Temporary Dental Repair Kit Twin Pack for Reparing Lost Fillings or Securing Loose Caps, Crowns or Inlays, 24+ Repairs

The DenTek Temparin Max Repair Kit Twin Pack is an easy to use, temporary treatment, designed to replace a lost filling, cap, crown or inlay until you have the chance to visit your dentist. It should only be removed by a dentist professional. Please visit your dentist within 48 hours of use. This home dental repair kit allows multiple applications, no mixing is required, is safe to eat on and has the same ingredients that dentists use for these repairs. It also includes an Applicator tool that helps you to easily secure the filling material to give you the best results. The kit provides 24+ repairs. Ingredients Zinc Oxide, Calcium Sulfate, Paraffinum Liquidum, Potassium Alum, Aluminium Sulfate, Aluminium Phosphate, Menthol, Eugenol, Iron Oxide Yellow Directions Directions to Replace a Lost Filling: Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of Temparin Max from the vial, and roll into a ball between fingers. Slightly overfill the cavity with Temparin Max and tamp into place with applicator tool tip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. Use a moist cotton swab to remove excess Temparin Max from around the area. Moisture will accelerate the set. Temparin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set. Directions to Secure Loose Crowns, Caps, or Inlays: Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, Temparin Max may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Scoop a small amount of Temparin Max from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. Temparin Max will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay. Safety Warning To avoid serious infection and/or injury, this product should not be used if there is stabbing pain, ulceration or swelling in the affected area. If any of these symptoms are present, consult your dentist immediately. Manufacturer Contact Information DenTek Oral Care Limited, Clockhouse Court, 5-7 London Road, St Albans, AL1 1LA