BRITA ON TAP Pro V-MF water filter for faucet including 1 filter cartridge (600l) - reduces 99.99% bacteria, chlorine, microplastics and heavy metals/digital LCD display shows remaining capacity

li> Note: Check that the adapter used is properly screwed to the end part of the valve (where the distributor is removed to connect the system) It is very important that the tap diameter respects the required measurements (minimum 22m and maximum 24mm) on and for the height of the thread (required parameters not less than 15mm). One of the causes could depend on the lime formation in the system. To avoid this, it is sufficient to periodically clean the components of the On Tap system. Pebbles and sand can cause a reduction in flow during the filtration process, preventing the screen from functioning properly. We suggest removing the filtered water dispenser, the steel grates and soaking them in vinegar to remove any residue, we also suggest spraying vinegar (natural anti-lime) on both unfiltered water dispensers and leave it to act for a few hours. in order to allow liquid to penetrate inside these non-removable dispensers. Finally, it may be helpful to tap the HF600L filter on a support surface to free the hollow fiber membrane contained therein of any residue. Then reset the battery according to the procedure in the instruction manual. The BRITA On Tap filtration system is not designed to reduce the temporary hardness of the calcareous water). Therefore, if you use filtered water for kettles or coffee machines, you may still see lime build-up and that annoying patina when using it to brew hot drinks like tea and coffee. The system optimizes the taste of water with bad chlorine taste, retains pesticides and herbicides, microplastics, lead and retains up to 99.99% of bacteria. The quality of the water that comes out is very important. Good water declared drinkable by the authorities who manage the water supply will make the filtered water taste excellent. We recommend that you activate the filter correctly according to the procedure and replace the filter in the manner and within the timeframe indicated by BRITA.