Cookology INT600SI DK1M120 Integrated Cooker hood | 60cm Built-in Kitchen Extractor Fan & Duct

Build this Fantastic little Extractor Fan seamlessly into your kitchen, by fitting a Cupboard door on the front that matches all your Kitchen units. When you open the cupboard, you open the extractor fan and expose the grease filter, light and controls and if you have left the lights and motor on, closing the cupboard will leave everything in standby mode, ready for when you open the cupboard again. The INT600SI will help to keep your kitchen smelling fresh and prevent grimy deposits on your walls and ceiling by absorbing grease from cooking. The 60cm width means that this Cooker hood is suitable for 60cm hobs or less. You get a useful light that is operated by a simple slider control and you get a choice between 3 speeds so that you are only using the extraction rate you need. If you're warming some soup you probably don't need the full 330 metres cubed an hour extraction rate and can choose a lower and quieter setting. You can either vent this Hood outside or recirculate the air back into your kitchen. When recirculating you need a CCF200 Recirculating filter (not included in this listing) that attaches to the motor to clean the air before it goes back into your kitchen. When venting outside you need a Ducting kit such as the DK1M120 120mm Ducting kit (included in this listing). This flexible hose takes the air out through a hole in your wall. Integrated Hood Features: Slider control operation Auto Switch off when you close the Cupboard Easily replaceable Paper Grease Filter Easy to Install 60cm wide 3 speeds 1 x 40W light Extraction capacity: 330 m3/hr Installation: For Recirculation you need CCF200 Recirculating Filters (not included in this listing) For Venting outside you need a DK1M120 120mm Ducting Kit (included in this listing) You put a cupboard door on the front Dimensions: Width: 600mm Depth: 282mm Height: 395mm