fischer Fischer Ultracut Concrete Screws FBS with Hex Head II 14 x 95 – 20

With up to 3 depths of inlay, ULTRACUT FBS II US allows you to use the same screw for different thickness of components. Product description: The Fischer ULTRACUT FBS II is the concrete screw for the highest demands in assembly. Special saw tooth geometry allows for quick cutting in concrete. When mounting on ceilings or floors, you do not need to clean the drills. Thanks to the national approval the multiple use of temporary anchors is regulated, e.g. in formwork. For mounting the wall screw, a tangential impact wrench with a nut suitable for the impact wrench or a special Torx bit. The concrete screw is ideal, for example, for fixing railings, impact protection, supports or formwork supports. Advantages: With up to 3 depths of inlay, ULTRACUT FBS II US allows you to use the same screw for different thickness of components. The special saw tooth geometry allows for fast cutting in concrete. No need to clean drilling holes during vertical installation (roof and floor). For floor fixings, the hole should be drilled 3 times deeper. The non-expansion anchor (recessed) allows for reduced distances between the edges and axles. ETA approval covers applications in cracked concrete and seismic power categories C1 and C2. The approved fitting for the concrete screws allows you to unscrew the screw twice to place a maximum of 10mm of gasket under the head of the base plate or to align the fixed part, and then re-tighten the screw. The control gauge allows for reuse on temporary fixtures (e.g. slanted supports) covered by the national approval Application and permissionApplications: Protective railings. Consoles / Base Plates Metal profiles. Siste