ANDALSYSTEM Tie Rod - Base for SAP3 Leveling Spacers - Laying Plates Thickness 0/12 mm - 1 mm Joint - Box of 4000 Pieces

Do you want to speed up and simplify the post of tiles? Improve the end result and eliminate disputes? Thanks to the ANDALSYSTEM systems, this is finally possible! Leveling spacers are perfectly fitting systems for large floor and wall coverings, created to have a perfect flatness and eliminate so-called "steps" between tiles. They are made in Italy and unlike other products on the market, they are made in NYLON. The tie rod is compatible with other systems on the market. The wedge is longer than other systems on the market for better performance on both low thickness and thickness. The base of the tie rod is very thin, but at the same time durable to slide quickly below the tile. Suitable for tiles from 0 to 12 mm. 1 mm escape rods Ideal for laying ground floor and floor coverings, large sizes, thin and thick tiles. Multiple advantages including: perfect flatness, never again "surprise of the next day" or steps between the tiles and avoid disputes. INSTRUCTIONS FOR USE: Place two or more tie rods below the tile about 10 cm from the corners. Place the next tile. Slide the wedges inside each tie by pushing forcefully to the alignment of the tiles. To remove them, no additional tools are required. Once the adhesive is hardened, it is enough to kick on the in-line escape tie to remove it. The wedge is reused for subsequent poses.