Bullnose Products Bullnose Rudder Clamp On Rudder Kit for 24-55 Thrust Trolling Motors: Accessory for Pedal Boats, Pontoons, Kayaks, or Canoes by Bullnose Products

PERFECT SOLUTION - Trolling motors are known for lack of steering especially when the wind picks up, the water is choppy or you want to track in a straight line. Simply add a Bullnose Rudder which is designed to give you better control of your watercraft in most windy conditions, help hold a true course at most trolling speeds, and prevent the boat from spinning as much when the motor is off.

ESSENTIAL - In most cases it helps hold a true course at both a slow and high trolling speeds. Customers have also said, “it prevents the boat from spinning as much when the motor is off”. Most tiny boats will benefit from having some kind of a rudder set up in the back vs not having a rudder at all. Only takes a few minutes to install and you are ready to go.

BOW MOUNT - Fits the Minn Kota, EDGE, MAXXUM, and FORTREX. The bow mount motor must be a hand cable pull, NOT self deploy. Self deploy will not work because the system requires the shaft to slide up and down right where the rudder needs to be attached. However, a hand cable pull will allow you to carefully bring the motor up out of the water on the motor mount. Your bow mount setup needs to have 1' of shaft sticking out from the end of the platform allowing enough space to attach the rudder.

International products have separate terms, are sold from abroad and may differ from local products, including fit, age ratings, and language of product, labeling or instructions.