Eltako Remote Sensor Temperature Controller, Pack of 1, Pure White Glossy, FTR65DS WG

Wireless Temperature Controller WG Pure White Glossy with display for retail installation 84X84X30 MM or can be inserted into the electric design switch system. Self powered with the integrated solar cell or with 12VDC Switch Mode Power Supply, or mix with batteries. Fully charged when you Ausliefer state the energy storage is blank and before operation. Either From The Red/Black/12VDC interface lead in about 5 minutes or over the solar panel in bright day light 5 hours, or by inserting Pack of 2 x AAA batteries (not included) in approximately 5 minutes. During normal operation to power supply either from the cable that connects with a 12 V DC Switch Mode Power Supply, FSNT61 -12 V/6 W in a for flush mounting under the sensor or with AAA batteries (not included) or AC power, supported by the solar cell, or just with the solar panel in a regular ambient brightness, in the daily average minimum 200 Lux. Is available only the solar cell, the energy storage must be charged with daylight several days before. The connection cable you need, it can be cut. This allows you the sensor No Depth Required behind the mounting plate and can be used on any flat surface be attached. Can be screwed can be the complete module from the frame. For screw fastening, we recommend Stainless Steel Countersunk Screws 2,9x25 mm, Pack C. Also can be used with wall plugs 5x25 mm 55 mm on button cans. 2 pieces Stainless Steel Countersunk Screws 2,9x25 mm and plug 5x25 mm are included. The sensor transmits all 100 seconds at a actual temperature, accurate change of at least. 0,3ºc a message in the Eltako covered building with wireless and the Bistabile display is updated. A to modify the set temperature will mail and the display is updated. If there is no change, so will 20 minutes a status message sent.