CMT ORANGE TOOLS CMT Orange Tools 739.317.11 – Beading Bit W/Brng Hw S=6 D=31,7X14

Manufacturer's reference: 739.317.11 TECHNICAL FEATURES When a job requires special singing, it is necessary to be able to choose with full freedom. CMT concave radius cutters give them a huge variety of profile choices, ideal for boats and visible furniture edges. When you lower the tool in such a way you discover the straight part of the cut: it allows you to add a decorative detail to the edges of tables, shelves and crossboards. Make two consecutive passes (turn the wood for the second pass) and then you can immediately perform the singing with double radius without having to buy another strawberry to round. The concave radius cutters Article 739-839-939 use a guide bearing smaller than concave radius cutters 738-838-938; therefore, along the lower part of the cutting you get a more slot. To convert your concave radio cutter with slot into a concave radius (and vice versa), it is enough to change the bearing. All concave radius cutters (except the 28.6mm (1-1/8") and 31.7mm (1-1/4") with a 19mm (3/4") bearings are equipped with a 12.7mm (1/2"). Concave radio cutters with slot have a 9.5mm (3/8") bearing. CMT offers them to choose between fifteen thirteen radio measurements, most of them with five different handles. Each cutter is equipped with micro-grain tungsten carbide segments. It is noteworthy that we also offer the highly sought after 1.6mm (1/16") and 3.2mm (1/8"). Tips: Use our drill bit with radius 1.6mm (1/16") for laminate edge finishes. By adjusting appropriately to the height of the cut will save the time required for the normally required sanding operation after using a normal milling cutter. Safety recommendations: pay special attention during the use of a strawberry with a large profile, and do not rush the work. Milling small pieces on the work table