NRS Healthcare Pedal Exerciser with Digital Display, for Rehabilitation Exercise

This Pedal Exerciser with Digital Display & Adjustable Resistance M37352 is designed for low impact rehabilitation and exercise. It is great for non-weight bearing exercise, as it is used from a standard seated position in a chair. This pedal exerciser incorporates an integral on-board computer that shows exercise time duration, calories consumed, cycles and revolutions per minute. The resistance of the pedals can be adjusted to increase or decrease the effort required to use the exerciser, therefore allowing for progressive increases in effort and fitness.The resistance knob for this product is supplied packed separately in the packaging. It simply screws into the main unit and can then be used to set the desired pedal resistance. To do this, turn the pedal resistance knob, clockwise to increase resistance (harder) and anti-clockwise to decrease (easier). It folds easily for storage by simply pulling on the integral ring on each leg, then folding the leg in. Unfold by pulling the legs out and they will simply snap into place. The pedals come complete with toe straps. Suitable for rehabilitation and gentle exercise. As friction is increased, or during long periods of vigorous exercise, the pedal and housing will become warm to the touch. Not a suitable alternative to a full size gym exercise bike or similar Measurement: Folded: 34 x 37 x 19 cm (13.5 x 14.5 x 7.5 inches). Operating: 48 x 37 x 27 cm (18.8 x 14.5 x 10.7 inches). Pedal: L10 cm x W4.5 cm (4 x 1.75 inches). Product Weight: 2 kg (4.4 lb). Note: Instructions need to be read to the ‘electronics’ to be set up correctly. If electronics are not working correctly, the battery needs changing to ‘reset’. Battery Replacement - Please note that this product is supplied complete with a battery. But if you need to change it here are the instructions. To access the battery, insert a small flat ended screwdriver into the slots on both sides of the digital display to release the clips. Lift the display out of the housing. Take care not to damage the connecting wires. Replace the battery and re-insert the display. Ensure the clips 'click' back into position securely. Please note: Please take care to thread the tension screw correctly when setting up this product, as if the screw is cross threaded it may be damaged so the product will not work. The tension screw needs to be turned several times to engage properly with the tension pad and provide the required resistance for the user.