Eltako WZR12-32A AC Meter with Reset Without Approval

Maximum current 32A, stand-by loss only 0.5 watts. Modular device for mounting on support rail DIN-EN 60715 TH35. 1 division unit = 18 mm wide, 58 mm deep. This AC meter with reset function measures the active energy based on the current flowing between input and output and stores the consumption in non-volatile memories. Like all counters without MID declaration of conformity in Europe are not approved for monetary electricity billing. The accuracy corresponds to all Eltako class B AC meters at MID (1%), the starting current is 20mA. The display is divided into 3 fields. Field 1: This display refers to the expected value in field 3. IIII slowly running to the right = field 3 shows the expected consumption since the last reset. This is the normal display. S01 = field 3 shows the consumption last full hour to S24 = 24 hours ago. T01 = Field 3 shows the consumption of last full days to T95 = 95 days ago. Field 2: Current value of power consumption (active power) in watts (W) or kilowatts (kW). The left and right display arrows show the automatic switching W and kW. Field 3: Expired value up to 9999 kWh. Display up to 9.999 kWh with 3 decimal places, from 10 kWh with 1 decimal place and from 1000 kWh without decimal place. With the MODE button on the left, the display options are brought to you and these are displayed in the field 1: S01 and T01 as described above. Finally, pressing MODE follows the country abbreviation of the set language. D for German, UK for English, F for French and ES for Spanish. With the right button SELECT the displayed number is increased by 1 within the display options with each press and the corresponding value is shown in the field 3. From the last full hour, the penultimate hour etc. If the active language has been selected with MODE so you can switch to another language with SELECT. If the new voice setting leaves MODE it is active. 20 seconds after the last mode or select operation and if both buttons are pressed briefly at the same time, the program automatically returns to the normal display. Reset: press MODE and SELECT buttons simultaneously for 3 seconds until RES appears in field 1. If Select is pressed briefly, all memories are set to zero. After that, the program automatically returns to the normal display.