3 Meters Silicone Shower Seal Strip,Bath Edging Sealing,Floor Threshold Water Barrier for Wet Room,Tile Edge Caulk Trim for Bathroom Bathtub,Countertop,Kitchen(20mmx12mm,Two Adhesive Backing)

Appilcation: Sink Countertop,Shower Cubicle,Shower Door Bottom,Bathtub,Shower Floor Installation method: Measure:Measure the length and width of the countertop, In the corner, we recommend you cut it to 45 degree, and then connect two part to ensure its firmness. Tear off the adhesive: in this process avoiding dust on the adhesive strip and affecting its adhesion. Paste: apply the water dam seal gently and slowly, keeping it horizontal or vertical, pressing gently with your fingers. Glue:The most important and necessary step is to fill the bottom edge of the water retention strip with caulk to ensure a long-lasting and strong adhesion. Cautions: In order to achieve stable and lasting effect , please pay attention to the follow question Purchase a size that is 5cm-10cm longer than the required length ! Clean the ground and dry it before installation! This floor seal suit for kinds of Smooth flat floor, such as smooth marble floor, coating floor and other smooth surface. can not use for Severe sags and crests floor, big gap floor and Mosaic glass floor. Not peeling all of sticker one-time: Mark the position and measure suitable length before peeling sticker, peeling sticker little by little one side and then press the peeled position to the surface as the same time, then peeling left little by little. Not peeling all of sticker for one-time and pull up the water retaining strip if found its not install well. use with silicone sealant: Fill the gap between the walls with the two ends of the water barrier and all around of bottom by silicone sealant to achieve a completely hermetic effect, remove the excess glue to make the contact smooth. After the installation is completed, it needs to be kept dry for 24 hours, and it needs to be postponed for 1-2 days in autumn and winter.