Amazon Basic Care 6 Day Early Pregnancy Tests (Pack of 3 Tests)

Product Description Allow Pregnancy Test to reach room temperature (15°C - 30°C). Remove the Pregnancy Test from the foil pouch and use within 1 hour. Hold the test by the thumb grip and remove the cap but do not discard it. Urinate into a clean, dry glass container, then, holding the test upright; dip only the Absorbent Tip into the urine for at least 15 seconds. NOTE: Do not allow urine to come into contact with the Result window. Hold the test by the thumb grip with the exposed Absorbent Tip pointing downwards directly into your urine stream for at least 15 seconds until thoroughly wet. NOTE: Do not allow urine to come into contact with the Result window. After removing the test from your urine, immediately replace the cap over the absorbent tip, lay the test on a flat surface with the test and control window facing upwards, and then begin timing. As the test begins to work, you will see the formation of a reddish-purple line in the Control region (C), indicating the test is working properly. Some positive results may be observed after 1 minute depending on the concentration of hCG but leave for up to 3 minutes for a line to appear in the Test region. IMPORTANT! Read results within 10 minutes. Discard the test stick after this time. After 10 minutes you should disregard any change in the result or any lines that appear after this time. If no coloured line appears in the Control region (C) within 5-10 minutes the test has not worked properly. Manufacturer Contact Information Pettifor Healthcare Limited Suite 12, Bingham Enterprise Centre, Mercia Court, Chapel Lane, Bingham, Nottinghamshire, NG13 8QX complaints@pettiforhealthcare.co.uk