pzsmocn GPS/BDS LORA GSM Support,Docker-Pi IoT Node Communication,Satellite Positioning Module,Support Raspberry-Pi All Models,Extend the GPIO Pins,Can Stack with Other Docker-Pi Board,I2C Support.

INTRODUCTION DockerPi series IoT node communication module LORA GSM GPS supports satellite positioning module I2C directly controls Lora, sends and receives data, controls the GSM/GPS/BDS module through SC16IS752.Can Stack with other Stack board,Independent of the mainboard hardware (require I2C support).Control directly(without programming). Specifications GPRS section - Low power consumption, standby sleep current <1mA - Support GSM/GPRS four frequency bands, including 850, 900, 1800, 1900MHZ; - GPRS Class 10; - Support GPRS data service, maximum data rate, download 85.6Kbps, upload 42.8Kbps; - Support standard GSM07.07, 07.05 AT commands, and access the serial port through I2C interface conversion. - AT commands support standard AT and TCP/IP command ports GPS section - Support BDS/GPS joint positioning - Support A-GPS, A-BDS - Support standard SIM card LORA section - Transmission distance:500 Meters (RF parameters: 0x50 @ China City) - Support FSK, GFSK, MSK, GMSK, LoRaTM and OOK modulation methods - Ultra-high receiver sensitivity as low as -141 dBm - Support preamble detection - Packet engine with CRC, up to 256 bytes - LORA transceiver indicator - Easy TX/RX by Docker Pi DISTRIBUTION LIST IoT Node(A) Board * 1 433MHz L-Shaped Tape Antenna * 1 2.4GHz PCB Antenna * 1 GPS/BDS High Gain GPS Built-in Ceramic Active Antenna * 1 M2.5*12 + 6 Copper stick * 4 M2.5*6 Nut * 4 M2.5*6 Half-round head screw * 4